PM5563 Schneider (sq D) power monitor

remullis · Nov 28, 2018

Has anyone had success mapping the PM5563 to controllogix. I am able to get information from the unit to the plc but I don't know the actual mapping and what is needed to manipulate the data. I have had no luck with Schneider on this one.

Thanks
RM

tragically1969 · Nov 28, 2018

remullis said:
Has anyone had success mapping the PM5563 to controllogix. I am able to get information from the unit to the plc but I don't know the actual mapping and what is needed to manipulate the data. I have had no luck with Schneider on this one.

Thanks
RM

What do you mean mapping, do you mean from PLC to Contrologix ?

The PM5xxx Modbus register list is publicly available:

https://www.schneider-electric.co.uk/en/faqs/FA234017/

I am not familiar with Contrologix but if you have it at the PLC it shouldn't be much of a task to get it right ?

remullis · Nov 28, 2018

I downloaded the register map and will give it a shot. Thanks for the information.

remullis · Nov 28, 2018

I just realized this register list is for Modbus. I am communicating through E/IP. Anyone have anything on this protocol.

tragically1969 · Nov 29, 2018

remullis said:
I just realized this register list is for Modbus. I am communicating through E/IP. Anyone have anything on this protocol.

Might have been useful to state which protocol you were using in your OP, either way it's all in the manual:

http://www2.schneider-electric.com/...S/234000/FA234023/en_US/PM5500_User_Guide.pdf

Note the firmware revision required for E/IP is 2.5.2 and above

PM5563 Schneider (sq D) power monitor

remullis

Member

tragically1969

Member

remullis

Member

remullis

Member

tragically1969

Member

Similar Topics