Versamax PLC can communicate with two cimpicity SCADA system with SNP

monto

Member
M
Join Date
Nov 2005
Location
pune
Posts
17
Hello All

I have an existing GE Fanuc Versamax Cpu05 system with Cimplicity SCADA 6.1, Now we have ordered one more Cimplicity system for our new plant .
I want to ask you if it is posible to view some screens of old system into new SCADA.

Thanks

Monto
 

Similar Topics

A
Unable To Connect To GE PLC VersaMax
Hi, The VersaMax PLC suddenly stop running (no LED on run function) so I'm trying to upload the program. The HMI connected to it says "Host...
Replies
0
Views
128
Adele
A
S
GE VersaMax Micro-64 PLC Ethernet Option Module IC200UEM001
Hi, I am trying to set the IP address on the IC200UEM001 Ethernet Option Module. I am following the procedure in the manual for setting a...
Replies
1
Views
423
sp_
S
B
Versamax PLC IC200UDR005-CJ fault
Hello! Our PLC stopped working.(Controller CPU hardware failure) What can we do? https://prnt.sc/txskqe
Replies
3
Views
1,805
Steve Bailey
Steve Bailey
E
Connecting to a VersaMax micro plc
I'm trying to utilize a PLC that my employer already had on hand for a project. For the life of me, I can't figure out how to get my computer and...
Replies
14
Views
5,074
Steve Bailey
Steve Bailey
D
Versamax micro Plc Ge fanuc
Every time i turn off and turn on the PLC, PLC is not going to RUN mode In the fault table it shows error " system Configuration mismatch" And...
Replies
4
Views
1,745
Steve Bailey
Steve Bailey
Back
Top Bottom