hour meter fo ti505 programming

bdonohue

Guest
B
Does anybody know a way to program in ti505 logic for a hour meter on a pump?
We are doing studys on pumps (how long they run for PM's)
I was just going to use the contact coil for pump to start a counter or timer. but it needs more programming to get it to hours of running?
Thank You
Bob
 

Similar Topics

Hi team, I am setting up my first E200 overload unit. I came across parameter 205 StartsPerHour. The default setting is 2. I presume, the motor...
Replies
2
Views
469
Hi all , Good day to everyone. Can any one suggest how to program for hour meter In Rockwell L72 processors. I’m using power flux 527 in...
Replies
64
Views
19,790
Hello all, I have been tasked with moving a mechanical run hour meter of a pump motor to a panelview. I have a slc 5/04 and an allen bradley PV...
Replies
6
Views
2,655
I am trying to record the run times and on-load times of 3 pumps in TIA Portal as hour meters. I want to monitor these on my HMI. I'm not familiar...
Replies
10
Views
8,561
Hi, I am using GE Fanuc PLC to calculate the Flow rate in cubic meter per hour from pulses output. i.e. Pulses per second. But the method i used...
Replies
10
Views
12,649
Back
Top Bottom