zephxiiii
Member
So I have a Micrologix 1500 LSP that was running a test station, but suddenly stopped (while I was on vacation).
It lights up with the power light, run light lights up when switch is put into run mode, and the COMM 0 light blinks here and there. If I push the DCOMM button, DCOMM lights up... but I can't connect to it from laptop using the front port.
Now if i plug my cable into another one that is running, it shows up in RSLinx as available etc., but this one will not.
I'm pretty much a newb so looking for some suggestions.
It lights up with the power light, run light lights up when switch is put into run mode, and the COMM 0 light blinks here and there. If I push the DCOMM button, DCOMM lights up... but I can't connect to it from laptop using the front port.
Now if i plug my cable into another one that is running, it shows up in RSLinx as available etc., but this one will not.
I'm pretty much a newb so looking for some suggestions.