      |
||
 |
||
    This board is for PLC Related Q&A ONLY. Please DON'T use it for advertising, etc. |
||
 Try our online
PLC Simulator- FREE.
Click here now to try it.
| ||
New Here? Please read this important info!!!
February 16th, 2005, 08:33 PM
|
#1 |
|
Member
 
Join Date: Jan 2005
Posts: 3
|
Speedtronic Mark IV Interfacing
Is anybody has successfully interfacing General Electric Speedtronic Mark IV Gas Turbine System to HMI (e.g InTouch HMI)?
I have a project to create HMI console for Speedtronic Mark IV, but still do not have an idea how to connect Speedtronic to HMI. Thank You |
|
|
February 17th, 2005, 05:56 AM
|
#2 |
|
Member
Join Date: Oct 2004
Posts: 1,047
|
I once integrated the GE SpeedTronic MKV to a Bailey DCS.
It was clunky back then (and probably is still now). We had to do Modbus from the GE HMI - PC RS232 Port to the Bailey. What a pain. Problem is that the GE system is proprietary and I don't think that there are any 3rd party drivers for it. Too bad. Since the GE SpeedTronic is for high speed processing on the turbine (think about it - running combustion at ragged edge of the cycle takes high speed processing) integrating a 3rd party I/O server and HMI would detract from the system. Hopefully you may find something that works. Good luck. |
|
|
|
October 6th, 2006, 04:53 PM
|
#3 | |
|
Member
Join Date: Oct 2006
Location: puerto la cruz
Posts: 1
|
informacion
Quote:
|
|
|
|
 |
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Topics
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PLC-DCS interfacing............. | swapnil | LIVE PLC Questions And Answers | 11 | July 31st, 2003 08:06 AM |
You are not registered yet. Please click here to register!
Linear Mode
