SKW Automation
Member
What is the cable pin out for a DF1 cable to communicate from the 9 pin connector on an Allen Bradley SLC 5/04 to a Panelview 550 9 pin DF1 connector?
DF1 cable pin out
- Thread starter SKW Automation
- Start date
DF1 cable
http://www.plctalk.net/qanda/showthread.php?t=12272&highlight=DF1+pinout
A Panelview 550 and 600 comm's are the same for DF-1 port.
See this thread. See post #5. It is for a Panelview600.It uses a straight thru serial cable. Pin 2 to 2, 3 to 3, 5 to 5, only.
http://www.plctalk.net/qanda/showthread.php?t=12272&highlight=DF1+pinout
A Panelview 550 and 600 comm's are the same for DF-1 port.
See this thread. See post #5. It is for a Panelview600.It uses a straight thru serial cable. Pin 2 to 2, 3 to 3, 5 to 5, only.
Similar Topics
Does anyone know if it is detrimental to use a FULL straight through cable to connect these two. I know that the AB cable does not carry pin 9...
Tried a straight through 9-pin RS-232 and a null model cable. No luck so far.
hello,
I am struggling to find the right communication cable pinout between vijeo designer and micrologix 1000 df1 for simulation purposes, and...
I am trying to find a serial cable to talk toslc 5/04 on the db9 port via rs232/DF1
I know there is a straight and angled version of this but i...
Folks,
A SLC503 used to be connected to the Internet via a Digi One IAP. During program download to the PLC the Internet connection was...
