Fx-10dm

[stevebarker]

Hi

I have purchased an FX1S PLC to control a simple assembly jig.

I have three sensors to detect that the correct parts have been installed, a start switch, proximity switch and two outputs,a red light for fault and green for ok

I had never done any PLC programming before but I have managed to write a programme that works just using inputs, outputs and timers.

However i have also purchased an FX-10DM-U-E display module.

I would like to use the display for a few simple messages i.e. Start test, Testing, Faulty, OK. etc. but i am having problems working out how to do this.

I would appreciate your help.

Steve