      |
||
 |
||
    This board is for PLC Related Q&A ONLY. Please DON'T use it for advertising, etc. |
||
 Try our online
PLC Simulator- FREE.
Click here now to try it.
| ||
New Here? Please read this important info!!!
December 12th, 2008, 03:29 PM
|
#1 |
|
Member
 
Join Date: Dec 2008
Location: Zagreb
Posts: 15
|
Beckhoff CX1500-M510 CANopen Master and SAE J1939 diesel gensets
Hi, I'm new here and I don't know is this topic belong here?
I would like to know if somebody have experience in putting Beckhoff CANopen master in raw CAN master mode to try to communicate or just receive broadcast messages from diesel genset in J1939 protocol? I know that J1939 converters to Modbus exist and can be purchuse on internet but I'm curios if this is possible. |
|
 |
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
You are not registered yet. Please click here to register!
Linear Mode
