![]() ![]() ![]() ![]() ![]() ![]() |
||
![]() |
||
![]() ![]() ![]() ![]() This board is for PLC Related Q&A ONLY. Please DON'T use it for advertising, etc. |
||
![]()
|
New Here? Please read this important info!!!
![]() |
#1 |
Member
![]() ![]() Join Date: Dec 2010
Location: Logan, WV
Posts: 3
|
Baldor Drive Commissioning problem/error
Drive: Baldor MicroFlex FMH2A09TR-EN43
Motor: Baldor BSM80B375AF Software: Baldor Mint Error: Internal Drive Fault -> Internal Power Trip Situation: Software seems to run fine. The Commissioning Wizard makes it all the way to the Tuning section. That's when the error shows up. Feedback from the encoder and hall effect sensors work fine. I can't find any info on the error. I'm using 120V single phase to power the drive. The internal bus voltage is steady at 170V. I've updated the firmware and reset the factory defaults. The error just won't go away. I have multiple drives and they all have the same error. Any information would be appreciated. I'm stuck. |
![]() |
![]() |
#2 |
Member
![]() ![]() Join Date: May 2003
Location: toronto
Posts: 105
|
could be the hardware of the enable signal
|
![]() |
![]() |
#3 |
Member
![]() ![]() Join Date: May 2002
Location: Kalamazoo MI
Posts: 2,305
|
Disconnect the encoder and try to run the system open loop (V/Hz). If it runs ok that way, the problem is related to the encoder somehow.
|
![]() |
![]() |
Bookmarks |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Commissioning procedure | Mahdi Elkawafi | LIVE PLC Questions And Answers | 1 | April 30th, 2010 02:54 PM |
Configuring a step 7 network with an "extra" profibus master PLC for commissioning? | oregonsam | LIVE PLC Questions And Answers | 4 | March 10th, 2008 10:06 AM |
GL150 commissioning | GL150 | LIVE PLC Questions And Answers | 0 | February 23rd, 2008 01:28 AM |
Commissioning Standards | sparky64 | LIVE PLC Questions And Answers | 9 | July 8th, 2003 02:58 PM |
Commissioning | mhwork | LIVE PLC Questions And Answers | 0 | September 26th, 2002 03:15 AM |