JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser .
hi there
i would just like to ask if anybody is familiar with the mitsubishi model fx1-32mr, it is an an old version of mitsubishi plc and im having hard time to find its specification on the internet. a little help goes a long way..
bless you,
theripley
The fx1 is an older plc and is now obsolete.
But it is still perfectly programable by-gx dev or even older software
the 32-mr means it is a 32 I/O model (i think 16 inputs and 16 outputs)
The mr bit means it is a 'relay' output type.
The internal bits and memory is mapped like the picture below
Tnx A Lot.. Its A Great Help
Hello,
I have a question on my HNC electrical and electronic engineering assesignment which has me stumped after hours of looking through PDF...
0 -|X0|---------------------------------[MOV k0 d0]-
6 -|M8|----|T0/|----------------------------(t0 k5)-
............|--|T0...
Hey! I have a transistor output FX1 14MT and I can't figure out how to wire it.
(One of these...
Dear all,
hi to all PLC experts! I am trying to connect to proface HMI with my mitsubishi FX1s PLC but always failed to connect.
the HMI manual...
Dear all,
hi to all PLC experts! I am trying to connect to proface HMI with my mitsubishi FX1s PLC but always failed to connect.
the HMI manual...
i would just like to ask if anybody is familiar with the mitsubishi model fx1-32mr, it is an an old version of mitsubishi plc and im having hard time to find its specification on the internet. a little help goes a long way..
