Mitsubishi FX3U to Q series PLC Conversion

jonfarrugia

Member
J
Join Date
Mar 2008
Location
London
Posts
130
I am working on a project that currently has a 64mb FX3U Mitsubishi running at a scan rate of 88ms. In order to improve the scan rate we are looking at converting the current processor to a Q series Mitsubishi PLC. I've been told that it is 4 times faster then the FX3U PLC. I've never done this conversion before and I was wondering how difficult it would be. I was hoping you guys could shed some light on the situation.
 

Similar Topics

A
Open Source SCADA Software for Mitsubishi PLC FX3U Series
Does anyone here have suggestions of open source SCADA software that can be used for Mitsubishi PLC FX3U Series. I want to monitor its data...
Replies
2
Views
2,828
goghie
G
G
Mitsubishi - FX3U + FX3U-USB-MB + FX3U-485ADP-MB - Modbus configuration - Paramètres
Bonjour, Je n'ai pas de communication modbus RTU vis la configuration ci-dessus. J'ai essayé les deux mode ch1 et ch2 mais rien ne fonctionne...
Replies
0
Views
175
Gael Boucekkine
G
I
Mitsubishi Fx3U 32M internal Error
Hello everyone; I have Mitsubishi PLC FX3U 32M in hydropower plant governor, an error message popped up when a technician was working on an...
Replies
2
Views
384
Ihtisham2
I
J
Error on HMI , PLC is a Mitsubishi FX3u-48m
hmi keeps saying "insufficient sensor failed" after the machine runs for 60 seconds. its a fx3u-48m PLC. The plc is not giving any errors or...
Replies
14
Views
2,280
Nova5
N
W
Proface HMI to Mitsubishi FX3U PLC RS422
Hello All, I have been trolling through the Proface documentation to find an answer, but I read conflicting information. We have a...
Replies
8
Views
3,944
woolie161
W
Back
Top Bottom