spaceacealpha
Member
Does anyone have an example program of the programming between a CJ series Omron and a barcode reader that uses Ethernet I/P? Anything can help, I learn by example more than anything. Thanks, Darren
Omron CJ to IFM Barcode Reader using Eth I/P
- Thread starter spaceacealpha
- Start date
spaceacealpha
Member
OP
Ok, I found an example, its set up a lot like devicenet. I have to use network configurator to set up 450 bytes in and out and simply send a 00002T command to start a test and look for a return.
Similar Topics
I've come across a system running omeron cx-programmer version 9.42. Am I going to need to find a legacy version of the software to edit and...
Has anyone done SMS messaging from an Omron CJ2J-CPU31 PLC? If so could you help please. Omron here in Oz have not had any experience doing this...
I have an old plc in the system I have, moxa nport was used to communicate with scada, I want to replace the plc with cj2m cpu33 and eliminate...
Hi all,
i have 8 CJ2m plc units that show different numbers on the plc display and i am stuck on reading the info.
my unit has an ip address of...
Hi all,
Currently having trouble getting a speed reference to write over modbus to an Omron M1...
I can successfully write a run command and...