This is all very new to me.i need help as i am trying to communicate 2 omron CJ1M PLC's on an ethernet using cx-programmer. Basically, i just want to run a simple ladder logic on one PLC which then communicates to the next PLC to excute its ladder logic. I dont know how to call the other PLC when i am doing the ladder logic in cx-programmer. Do I need to set up a network in cx-programmer? If so, how do i do that. All help is appreciated very much....
Plc To Plc Communication Using Cx-programmer
- Thread starter supafly
- Start date
I have not and do not use Ethernet for peer to peer communications. I use Controller Link. However, the setup should be the same I would think.
Yes, you have to set up a network in CX-Programmer/Integrator. Go to "Tools" and "Network" and set it up from there. I am using CX-One V1.1 by the way.
Yes, you have to set up a network in CX-Programmer/Integrator. Go to "Tools" and "Network" and set it up from there. I am using CX-One V1.1 by the way.
Similar Topics
i have two plc
1. s7-1212dc/dc/dc ip; 192.168.0.1
2. s7-1500 1513-1pn ip; 192.168.3.2
i need to get data from plc1 to plc2. any idea how to do...
I have created a project in TIA Portal v16 Upd6 with S7-1200 (6ES7214-1AG40-0XB0) and WinCC Unified (PC station). The communication between the...
Hello
We have installed several G.E. Fanuc 90 70 PLC
Everything was ok but suddenly we can not communicate anymore with any PLC with the software...
Apologies for not being the best IDEC programmer. I recently was doing some inspections on a site that had 3 FC6A IDEC processors. The issue is...
I'm trying to write a data in Arduino using MODWR function block .I used the code I got from online for both PLC and Arduino. I made the wiring...