Hi guys, so I'm using BOOTP/DHCP tool in my virtual machine for setting up an IP addresses for basically everything.
My only issue is always with ArmorStarts, we have lets say 20 ArmorStarts in one loop and when I open BOOTP it find all MAC Addresses, but after setting up IP addresses and disabling BOOTP/DHCP for 2 ArmorStarts the next I want to set up and disable BOOTP/DHCP will just ignore me and show me some message, I need to manually cycle power and wait for awhile until I can set up next armorstart, I need to repeat this every 2 ArmorStarts I set up which is quite annoying and it is slowing down the process.
Do you have any idea what could cause this or have similiar problem?
btw. all ArmorStarts in loop are same models (294E-FD1P5Z-G3), note that this problem does not occur in case of ArmorBlocks/PowerFlex/Kinetix ...
Thanks for your :site:help!
My only issue is always with ArmorStarts, we have lets say 20 ArmorStarts in one loop and when I open BOOTP it find all MAC Addresses, but after setting up IP addresses and disabling BOOTP/DHCP for 2 ArmorStarts the next I want to set up and disable BOOTP/DHCP will just ignore me and show me some message, I need to manually cycle power and wait for awhile until I can set up next armorstart, I need to repeat this every 2 ArmorStarts I set up which is quite annoying and it is slowing down the process.
Do you have any idea what could cause this or have similiar problem?
btw. all ArmorStarts in loop are same models (294E-FD1P5Z-G3), note that this problem does not occur in case of ArmorBlocks/PowerFlex/Kinetix ...
Thanks for your :site:help!