Siemens PXC 100 programming software

[obi1987]

Can anyone tell me which software is used for Siemens pxc100 d controller.

 

[Lancie1]

From Siemens Building Technologies- Automation Stations Modular Series PDF datasheet CM1N9222en_10, 2014-03-31

Programming Language
The automation stations are freely programmable in D-MAP programming language. This involves the creation of plant operating programs through graphics based interconnection of function blocks and compounds held in libraries.

Communication

​

Communication is via Ethernet with the internationally standardized BACnet protocol. Both peer-to-peer communications with other automation stations and connection to the PXM20-E operator units are supported.​

The devices communicate via an open LonTalk system in accordance with the international standard BACnet protocol. Both peer-to-peer communications with other automation stations and connections to the PXM20 operator units are supported.​

The devices communicate via the public telephone network in accordance with the international standard BACnet protocol.​

 

[obi1987]

I found one from siemens but its very Different I am Unable to upload the program.

Desigo