Slc 5/03 and microview 2707-mvp232
- Thread starter nmk
- Start date
The Microview Operator Interface was not made to work with SLC 5/03 PLCs, or any other except for the MicroLogix. To make it work would require some engineering and a custom-made cable. Even then there could be problems. Many SLC 5/03 will not have the 24 volt DC power available. The RS-232 port on the SLC 5/03 has a different pin configuration than the MicroLogix.
Last edited:
Similar Topics
I’m attempting to send a temperature from a SLC-5/02 to an EZiMarquee display. The vendor said to use a MSG instruction to send the data to the...
Hello all. I have a few SLCs in my plant and of late we've seen a weird issue: The system will be running normally and then randomly the outputs...
I am working on setting up a Prosoft Datalogger model PLX51-DLplus-232. This unit will be collecting data from a SLC 5/05 on the DB9 port set to...
I have a redundant ControlLogix being set up. This program reads a value from a remote site which happens to be SLC PLC. Rockwell mentions SLC...
Hello, I have a ControlLogix redundant controller being set up. The program reads a value from a remote site which hosts a SLC PLC. Rockwell...