ControlLogix and Domino printer
- Thread starter asteroide
- Start date
celichi
Lifetime Supporting Member
Wow, looked it up out of curiosity, and the company is close to me.
Anyway, they are an encompass partner, and have the ODVA and Ethernet/IP logos on the website.
My suggestion would be to read the manual for the printer, the information you seek is probably in there.
I was not able to find that information on their website, you will probably have to call or email.
Good Luck!
celichi
Lifetime Supporting Member
It is not online that I could find, I think you will have to email them.
alive15
Member
Celichi, your avatar is so confusing, haha. Who programs using 1 as no alarm and 0 as an active alarm. Or maybe I am the naïve.
celichi
Lifetime Supporting Member
Haha it is supposed to be.
I came across that early in my career in E-Town KY at a Dana Plant.
Never forgot that comment or that programmer.
I was there bailing out some c++ programmers who thought PLC was below them.
I always push people to name digitals in the positive state, just describe what on means.
drbitboy
Lifetime Supporting Member
I do enjoy the creativity people attach to their accounts; check out Ron Beaufort's signature:
alive15
Member
I don't get Ron's, the output is always going to be on? What is the moral of this logic? Is he trying to say there are multiple ways to achieve an end goal? Or are there no morals, but just describing a new or confused plc programmer, haha.
---
Your signature is interesting too Dr. Bitboy, haha. That one applies to life in general.
---
Your signature is interesting too Dr. Bitboy, haha. That one applies to life in general.
MasterBlaster
Lifetime Supporting Member
Shakespeare: To be or NOT to be . . .
drbitboy
Lifetime Supporting Member
Yeah, it took me a while too: I thought it was a puzzle/teaching exercise for quite some time.
AlfredoQuintero
Lifetime Supporting Member
When I first saw Ron's signature years ago, shortly after having found this forum, I got the joke immediately and could not stop laughing for about 15 minutes.
Celichi's avatar is very hilarious, and there are some avatars and signatures which are very funny too.
Contr_Conn
Member
Check Rockwell knowledge base, it should be a technote on how to use Sockets with printers.
In this manual I don’t see a port number that printer is listening on, so I would try default from the tech note first.
In this manual I don’t see a port number that printer is listening on, so I would try default from the tech note first.
celichi
Lifetime Supporting Member
Yes, that is very clever!
alive15
Member
Wow that is pretty clever! Good job Ron!
Similar Topics
Why does the controllogix redundancy modules use a single mode fiber vs multimode fiber?
Hello,
I have two 16 point input cards and 1 16 point output card showing module faulted on my IO tree in Logix Designer.
The fault code is...
Hello,
My associate and I are trying to sync up two ControlLogix racks (7-slot chassis) with identical modules. We are able to see the secondary...
Trying to setup a message read via Ethernet.
I have the path setup as 1, 1, 2, 192.168.66.10
I get an error code 1, ext err 315.
I am beating...
I have a redundant ControlLogix being set up. This program reads a value from a remote site which happens to be SLC PLC. Rockwell mentions SLC...