I want to drive a servo amp MR-J4 in position control mode by using pulse train signal. I have FX3U but i think it's source output type (common output is V+).
Up on reading J4 manual, pulse train input to J4 is either open-collector type or differential type.
I'm still a beginner and not sure that would it be possible to drive J4 with this FX3U. Any help and advice is greatly appreciate.
Up on reading J4 manual, pulse train input to J4 is either open-collector type or differential type.
I'm still a beginner and not sure that would it be possible to drive J4 with this FX3U. Any help and advice is greatly appreciate.