jamaljbenoit
Member
I have a couple PVA files that I am unable to open. I have tried re-installing PB32. I have used versions 2.6 and 3.83. Want to see if anyone else has better luck than me.
Thanks
Thanks
Cannot open PVA file
- Thread starter jamaljbenoit
- Start date
jimtech67
Member
I cannot open either..
Tried on Win 10 and Win 7 laptops..
I get message reading file is may be corrupted...
Tried on Win 10 and Win 7 laptops..
I get message reading file is may be corrupted...
Operaghost
Member
I got a message
Unable to load file. Not a PanelBuilder32 file or file is corrupted or disk space is low.
Disk space isn't an issue. I am using version 3.83.01 in Windows 7 and also on XP. Tried version 2.60 on XP too.
OG
Unable to load file. Not a PanelBuilder32 file or file is corrupted or disk space is low.
Disk space isn't an issue. I am using version 3.83.01 in Windows 7 and also on XP. Tried version 2.60 on XP too.
OG
jamaljbenoit
Member
OP
Same errors I am having. I have tried both Windows machines and XP machine also.
Similar Topics
Hi, Im trying to open an old old Siemens WinCC project.
It doesnt have to run i just want to look at the project in WinCC explorer.
Its...
Hi,
I received the following project from a customer on a QuickPanel Proface 6" that I need to swap to a Siemens Panel. However, I cannot seem to...
Hello,
I am having an issue trying to open or create new projects which have L8 CPUs inside. I have tried with several versions of Studio5000...
Hi all,
I am having this strange issue with FT view SE where it won't allow me to open the project. I've attached the error for reference. It...
Hi,
I have a setup (first for me) with a Micrologix 1400, PanelView Plus 7 and a Yaskawa A1000 drive.
Everything was working fine on Friday...