powerflex755, how to control the speed of motor in point to point

cctthh

Member
C
Join Date
May 2021
Location
korea
Posts
5
powerflex755,,,,


I set ptp as per page 128 of this document, but the motor does not work. I try to control using Absolute Encoder. Please let me know if there are any settings that need to be checked, not the manual.

please tell me
how to control the speed of motor in point to point:confused:
 

Similar Topics

ronny_resistor
Powerflex755 Torque control
Just wondering if anyone can send me a simplified Torque setup for a 40HP Allen Bradley 755 Powerflex drive. I worked all day manipulating what a...
Replies
3
Views
2,890
kekrahulik
K
M
PowerFlex755 output frequency is different to the reference command
Hello guys, I am new to this forum and have some problems with my PowerFlex755 EENET frequency inverter. I want to do a point to point...
Replies
9
Views
383
Lynx777
Lynx777
C
How to run a powerflex755 motor, Par Setting
Connect the powerflex755 to the encoder motor, and try to control the speed over Ethernet. The speed reference and communication port settings...
Replies
3
Views
2,034
widelto
widelto
N
PowerFlex755 on DeviceNet Timeout erre
I replaced a couple of 1336 Plus II drives with PowerFlex755 drives on my DeviceNet Network. The drives are functioning fine on the network but...
Replies
7
Views
1,753
Geospark
Geospark
K
PowerFlex755 'Net I/O Timeout'
Hello, I'm having a problem with a PowerFlex755 - every few seconds it faults on a 'Net IO Timeout'. The hardware configuration is really...
Replies
3
Views
3,829
Hoozie
H
Back
Top Bottom