I've been instructed to suck the program out of one plc and install it in another of the same model for the same process. This is my first attempt at trying this software or one of these PLC's.
The software we have is PG2000 V2.41 I found on 3.5 floppy disks.
I managed to get it to connect via rs232 and can view the PCC through Target > Monitor.
At this point I believe I'm supposed to open the GDM to show my current project, and then hit Project > Synchronize to upload to the GDM.
It shows some of the modules appear to upload, but then I get a message that says:
GDM Layer from PCC > RPS < Processor > CPU < not available
It behaves this way regardless of the key being in run or program mode.
I know very little about how this is supposed to work, so I feel stuck at this point.
Any help would be greatly appreciated.
The software we have is PG2000 V2.41 I found on 3.5 floppy disks.
I managed to get it to connect via rs232 and can view the PCC through Target > Monitor.
At this point I believe I'm supposed to open the GDM to show my current project, and then hit Project > Synchronize to upload to the GDM.
It shows some of the modules appear to upload, but then I get a message that says:
GDM Layer from PCC > RPS < Processor > CPU < not available
It behaves this way regardless of the key being in run or program mode.
I know very little about how this is supposed to work, so I feel stuck at this point.
Any help would be greatly appreciated.