Mas01
Member
We recently ran out of spare AD channels on our PLC and now I've just received a new Q68AD-G to give us extra capacity.
My plan:
1. remove one of the QG60 "blank cover" modules and plug the new module in.
2. GX Developer Configuration - Updating the I/O tab on GX Developer - this defines the start and end address of the new card [BUT how do I know the start/end addresses?]
3. Code update - I think I will need to add some extra code in the ANALOGUE section to configure the new card so that the PLC can read it.
Am I right in the above? Are there other things I need to do?
Thanks
My plan:
1. remove one of the QG60 "blank cover" modules and plug the new module in.
2. GX Developer Configuration - Updating the I/O tab on GX Developer - this defines the start and end address of the new card [BUT how do I know the start/end addresses?]
3. Code update - I think I will need to add some extra code in the ANALOGUE section to configure the new card so that the PLC can read it.
Am I right in the above? Are there other things I need to do?
Thanks
Last edited: