darkplc
Member
I was trying to upgrade a micro830 to firmware 12.013 and was unable to connect. I searched online several times with most results sending me here for unrelated issues. So, I thought I would post the solution in hopes someone in the future can find a solution faster than I.
After upgrading firmware from version 9 to 12.013 I could not connect or download to PLC. With the following error:
An error occurred while writing to customcommand.
After searching for hours online for a possible solution, I tried downgrading to version 12.011. Afterwards, I was able to connect with no problem.
Thinking that version 13.0 of Connected Components Workbench(CCW)could not handle 12.013 firmware, I looked online for a newer version.
On Rockwell's website, I stumbled on a patch for CCW specifically for the micro830 12.013 firmware. CCW V13 Patch for Micro800 FW 12.013
After installing the patch I could upgrade to firmware 12.013 and download just fine.
After upgrading firmware from version 9 to 12.013 I could not connect or download to PLC. With the following error:
An error occurred while writing to customcommand.
After searching for hours online for a possible solution, I tried downgrading to version 12.011. Afterwards, I was able to connect with no problem.
Thinking that version 13.0 of Connected Components Workbench(CCW)could not handle 12.013 firmware, I looked online for a newer version.
On Rockwell's website, I stumbled on a patch for CCW specifically for the micro830 12.013 firmware. CCW V13 Patch for Micro800 FW 12.013
After installing the patch I could upgrade to firmware 12.013 and download just fine.
Last edited: