Hello,
I have an FX3u-16MR/ES, FX3u-ENET (version 1.0), using GX Works2 Version 1.596W (Trial version).
Using FX Configurator-EN (version 1.0), the IP address of the FX3u-ENET is set and I can ping it with success.
GX Works2 fails to communicate with the PLC, via Ethernet, and all other software capable of communication with the PLC fails when using Ethernet.
I read one PDF about creating a new module under “Special Module...”. The only module listed is “AnyWireASLink”. Perhaps that is a limitation of the trial version. The document had “FX3u-ENET-L”. FX3u-ENET and FX3u-ENET-L seem to be different?
Any ideas?
Thanks,
Mark
I have an FX3u-16MR/ES, FX3u-ENET (version 1.0), using GX Works2 Version 1.596W (Trial version).
Using FX Configurator-EN (version 1.0), the IP address of the FX3u-ENET is set and I can ping it with success.
GX Works2 fails to communicate with the PLC, via Ethernet, and all other software capable of communication with the PLC fails when using Ethernet.
I read one PDF about creating a new module under “Special Module...”. The only module listed is “AnyWireASLink”. Perhaps that is a limitation of the trial version. The document had “FX3u-ENET-L”. FX3u-ENET and FX3u-ENET-L seem to be different?
Any ideas?
Thanks,
Mark