Randyjay
Member
When an eprom (ROHM) is plugged into a Omron Sysmac C28K PLC does it automatically load when the unit is powered up?
Omron Sysmac C28K
- Thread starter Randyjay
- Start date
http://omronkft.hu/nostree/pdfs/plc/cxxk/w147e31_c20k_c28k_c40k_c60k_installation_guide.pdf
Look at section 2-8 of the above manual. Pin 1&2 off / Pin 3&4 on
Regards,
Look at section 2-8 of the above manual. Pin 1&2 off / Pin 3&4 on
Regards,
Similar Topics
Hey all,
Hopefully I can get some help here; trying to help a friend get a program backed-up on his C28K which, obviously, is quite old. In...
bonjour ,
j'ai un automate omron sysymac c28k , j'ai perdu le programme de l'automate je veut le reprogrammer j'ai le programme mais j'ai pas le...
Gentlemen, I have purchased a machine which has an Omron Sysmac C28K PLC. What do I need to program it?
Please help with resetting "alarm" fault on this controller. Also information on correct cable and software for communication.
I took an online course but don't remember covering this.
How do I access the system clock in a compare instruction?
I want to turn on an output...