MSG ML1100 to 5/04 help

Im currently trying to setup a msg statement from ML1100 to a 5/04. Im using a AN-X2-AB/Ethernet Module to convert the DH+ to Ethernet. I have the modules address set to 192.168.1.10 and the ML1100 to 192.168.1.12 and I have communications with both. I tried setting up the ML1100 msg statement to read data from the 5/04 N7:0 but im not finding much info on how to properly set it up to get it to send data. Anybody have any insight?

Got it figured out.

stateline said:

Got it figured out.

Click to expand...

Could you tell us what you did to make it work, to help out some poor soul in the future with the same issue?

Create a MG and RI data file then add a MSG statement and make them like this with your nodes and ip address instead of mine. Do all of the setup on the ML1100, no programming is needed on the slc500 since I am pulling data from the slc500 into the ML1100. Also note that you can only make changes while offline.