I am trying to understand how Motor logic PLUS II works.
My questions is I am trying to send run command from PLC through Devicenet network. I mapped address in the Devicenet module in PLC.
But i am not understanding at motor Logic Plus II, which bit actually will be run command at motor logic plusII. Also since i am sending word through devicenet network whether it requires byte swap or not.
I read the Square D Motor logic plus manual and programming manual but i am not clear it.
If anybody please show me or little explain me it will be great help.
My questions is I am trying to send run command from PLC through Devicenet network. I mapped address in the Devicenet module in PLC.
But i am not understanding at motor Logic Plus II, which bit actually will be run command at motor logic plusII. Also since i am sending word through devicenet network whether it requires byte swap or not.
I read the Square D Motor logic plus manual and programming manual but i am not clear it.
If anybody please show me or little explain me it will be great help.