AJGS
Member
I have 2 X 17 slot chassis connected with EN2T cards
In Chassis 1 there is a 1756-L71 in slot 0 and a DHRIO in slot 1 + other cards
The program was converted from PLC5 and I am confused how/why it generated the IO in the remote SLC rack.
The remote rack is a 7 Slot chassis with a 1747-ASB plus
Slot 0 Empty
Slot 1 8 Analog in Card
Slot 2 8 Analog output card
Slot 3 8 Relay Output card
Slot 4 8 Output Control Chief Watchdog Card
Slot 5 Control Chief Remote control communications card
The Rack is configured as 10 Octal and the cards in the old system as
Slot 0 Empty
Slot 1 I:101
Slot 2 O:102
Slot 3 O:103
Slot 4 O:104
Slot 5 O:105
When the conversion utility was run, it generated eg,slot 4 as O[68]. The confusing bit is the 68 from 104. 104 decimal = 68 Hex, but I still don't understand why those numbers
In the program O[68].0 is on, however the output on the remote rack is not. the RUN on the Adapter is on and the DHRIO card is happy with a Green LED on for RIO.
Anyone can shed some light on this?
thanks
AJGS
In Chassis 1 there is a 1756-L71 in slot 0 and a DHRIO in slot 1 + other cards
The program was converted from PLC5 and I am confused how/why it generated the IO in the remote SLC rack.
The remote rack is a 7 Slot chassis with a 1747-ASB plus
Slot 0 Empty
Slot 1 8 Analog in Card
Slot 2 8 Analog output card
Slot 3 8 Relay Output card
Slot 4 8 Output Control Chief Watchdog Card
Slot 5 Control Chief Remote control communications card
The Rack is configured as 10 Octal and the cards in the old system as
Slot 0 Empty
Slot 1 I:101
Slot 2 O:102
Slot 3 O:103
Slot 4 O:104
Slot 5 O:105
When the conversion utility was run, it generated eg,slot 4 as O[68]. The confusing bit is the 68 from 104. 104 decimal = 68 Hex, but I still don't understand why those numbers
In the program O[68].0 is on, however the output on the remote rack is not. the RUN on the Adapter is on and the DHRIO card is happy with a Green LED on for RIO.
Anyone can shed some light on this?
thanks
AJGS