Getting Mitsubishi PLCs to talk via 422/485

Tony.Morgan

Member
T
Join Date
Apr 2002
Location
Brynaman, South Wales
Posts
9
I need to get 2 site plcs which are 100m apart connected using A1SJ71UC24-R4 cards. Basically I need to be able to map some digital points across from a new Q2AS plc to an existing A1S plc.
Both plcs are setup in ladder using GX Developer 7.01.
I have searched the Mitsi sites looking for any info on a similar application without success.
Any pointers on how to configure the cards, and map the required addresses would be much appreciated...
 

Similar Topics

L
Mitsubishi HMI Date & time getting Reset.
Hello Everyone I have a HMI Model - Model -GS2107-WTBD, HMI is n****e , While Downloading the Program to HMI the date & time getting Resetting...
Replies
3
Views
2,264
parky
P
Z
Mitsubishi Getting started
I am going to use Q02HCPU. I looked at the manual but am getting lost in there. Can someone please guide me in the right direction. For now I...
Replies
10
Views
7,711
Crossbow
Crossbow
D
Getting connected to Allen Bradley Ultra3000
Hi how's it going. Was just wondering if someone could help me out. Recently one of the guys over on the LinuxCNC forums put me onto getting an...
Replies
3
Views
37
Steve Bailey
Steve Bailey
N
Getting page fault exception error.
The application was working in Twincat 4022.16 Used VM for offline. recently changed the laptop and the getting the error with Message as below...
Replies
0
Views
69
Nag
N
N
WINCC SCADA getting this error
We are using wincc scada WinCC system software V7.5 SP2 , connected to few plc . Past 3 weeks we getting this alarm continously when we checked...
Replies
0
Views
97
Nimi4576
N
Back
Top Bottom