I am new to networking and am having trouble setting up communications from one PLC 5/03 to another over a local network using the MSG instruction. Can anyone give me an example so I may figure out what I am doing wrong? I tried programming this in but I have no luck. I get the message is enabled and waiting but not sent. Do these have to be in pairs or what? Can you give me an example that I may be able to follow?
AB message instructions
- Thread starter dgreen
- Start date
tom_stalcup
Lifetime Supporting Member
I don't have any 5/03's(dh485) networked here at my plant, but here is a sample 5/04(dh+) that is in place and working....
Take a look at this, and let me know what kinds of questions you have...
Take a look at this, and let me know what kinds of questions you have...
Similar Topics
I want to read several disparate values of different data types from a second PLC with the MSG instruction via CIP Data Table Read message type...
Hello -
I have a basic knowledge of PLC programming. I have programmed several Micrologix units over the years. Now I am getting into some things...
When creating a new input on a remote microLogix transmitting to the PLC5 via 9810 MDS Data Interface on Channel 0. Will the data file...
Hi,
I'm using message instructions for the first time and I have a very fundamental question that I'm surprised I could not answer with a google...
I am currently using PLC's CPUE05 versamax GEFANUC, I get an error "system configuration mitmach" but could not overcome. Although I've replaced...
