xmp-820
- Thread starter amolaaa1
- Start date
Arun
Member
Hi,
this is very good PLC as failure rate is very low. It comes in various I/O configration. 16 input 8 output and so on also expansion modules are also available. It requires DMP software for programming.It is manufactures in India at pune in maharastra.
From Arun Tidke
Nashik Maharastra
this is very good PLC as failure rate is very low. It comes in various I/O configration. 16 input 8 output and so on also expansion modules are also available. It requires DMP software for programming.It is manufactures in India at pune in maharastra.
From Arun Tidke
Nashik Maharastra
Similar Topics
Dear ALL,
where can I get info on the following for the Messung XMP 15?
PLC info including Pin configuration
RS232C cable / pin diagram for...
I’m running a micro 820 to measure a tank level, then turning on equipment at certain levels. I have an analog input (4-20) that I’m storing and...
I’m trying to read values from a device that can either send registers as 32 bit or a pair of 16 bit but if I understand right, the micro can only...
Hello,
I set up my Micro820 with a basic mapping. When I try to run a script to read the addresses I get errors for illegal addresses...