Torque Sensor-Lebow

peng

Member
P
Join Date
Sep 2005
Location
Chicago
Posts
48
I need help in getting max torque out of a Lebow torque sensor which is driven by a servo motor. I have to write some PLC code in Logix 5000. I do have anlog input/output cards. I have not programmed in analog (only digital).

Can some one tell me how I can go about doing this.
 

Similar Topics

C
Limit HP from Torque AI and RPM PID Output
Hello, I have a motor that we are sending a RPM Speed Output from 0-100% to the VFD. However, the Motor HP needs to be limited to 6000 HP and the...
Replies
3
Views
107
Rob...
R
H
Motion control use torque loop in Rockwell Studio 5000
I have always controlled servos in Rockwell motion using position loop. I have an application where one process will push against a servo...
Replies
3
Views
293
robertmee
R
Bering C Sparky
Set max torque permissive value in PowerFlex 525
Hello, Would anyone happen to know what parameter in a PowerFlex 525 to have the drive trip if the torque permissive set point is exceeded...
Replies
3
Views
463
Bering C Sparky
Bering C Sparky
B
Gearbox effect on VFD torque limit
Possible dumb question here, but how does running a motor through a gearbox effect a VFDs ability to limit the torque on the driven load? My gut...
Replies
2
Views
542
Blue92
B
T
ACS Drive in Torque Mode - Torque Oscillation?
Hello, I am posting this question (regarding drive control) on this PLC forum because I see that there has been discussion regarding this issue...
Replies
2
Views
629
Total_newbie
T
Back
Top Bottom