Flex logix, 1794-IE8

dougiediner

Guest
D
Have a small problem, when setting up 1794-IE8 using 4-20mA signal. With RS 5000 is there a way to offset the counts 0-33840? Im not sure how the underflow bit works or if I can illustrate that negative counts represent a broken wire. At the moment if 3.99mA is detected it generates an alarm and stops the process. My thought is if the counts could be a portion higher then 0 counts could represent an actual problem with the instrument.

Doug
 

Similar Topics

P
How use sofware rslogix 5000 v16.0 calibrate flex module 1794-IR8
Anybody can help me. I already read document in software rslogix 5000 and I think i can use software rslogix 5000 calibrate for flex module...
Replies
0
Views
1,736
phamquoctrung
P
B
Installing a 1794-AENT FLEX I/O module .Can you install in CompactLogix while online?
Good Evening , I am getting ready to install a remote Flex I/O 1794-AENT. It is going to be difficult to shut the line down to install. I...
Replies
2
Views
2,344
Baker in Virginia
B
G
How to read HART signal parameter using flex io 1794 IE8H in rslogix 5000?
Dear all, I have 1794 IE8H Hart flex input module to which one Emerson HART flowmeter is connected...I have gone manual of flex module...I have...
2
Replies
20
Views
8,797
bmmaddy
B
A
Flex I/O 1794-IT8 and CompactLogix
So this is a first time I've had no choice but to use Flex I/O with anything RSLogix 5000. I've got everything up and running, but the values I...
Replies
2
Views
1,966
Ron Beaufort
Ron Beaufort
B
Control Logix w/Flex I/O 1794-ID2 - Flow Rate
I am using an oval gear meter with a pulse rate of 2050p's /L. I am trying to figure out how to program a rate counter to track flow rate at...
Replies
2
Views
2,637
ASF
A
Back
Top Bottom