fetch into HMI

ketal

Member
K
Join Date
Oct 2002
Posts
20
Hi World.

Could somebody tell me how to fetch I/O data from MomentumPLCs
into Indusoft V6.0(pc control is done by concept 2.6).
Thanks
 
It is dependent on the capability of your Indusoft. Can it read Modubus "0" (coils) and "1" (inputs) bit registers? Or (as is common) can it only read "4" word registers? The Momentum processor will respond to all proper requests.
 

Similar Topics

K
fetch into HMI
hi people: does anyone know how to fetch data from MomemtumPLCs into concept-webstudiov6.0? is it possible to get this directly into Concept...
Replies
0
Views
1,849
ketal
K
B
How to Fetch Controller Mode of Remote AB L8 PLC using CIP MSG
Hello All, is there any way to fetch remote controllers Mode Run/Remote Prog/Faulted etc. ( AB L8 Series) using CIP message, if yes please share...
Replies
5
Views
835
AlfredoQuintero
A
Moustafa Elsherief
PN fetch/write port numbers
Hello every body I linked Proface HMI "GP2500-TC41-24V" to S7-315 2PN/DP. As attached I have to enter PN port fetch/write port number. How...
Replies
2
Views
1,596
Moustafa Elsherief
Moustafa Elsherief
R
Fetch / Write S5 to S7
Hi guys, I'm wanting to set up a fetch / write on a s5 and s7. But i'm struggling to work out which i should use, if not both? I want to share...
Replies
0
Views
1,826
russg
R
A
remote data fetch in control logix network
hi.... I have a dual redundancy control logix plc on controlnet. There is also a panelview 1500 on the same network. I want to fetch the panelview...
Replies
1
Views
2,962
Ken Roach
Ken Roach
Back
Top Bottom