manasi
Member
Can anyone tell me how to set up PC to plc communication on RS-232 port (AB-DF1 driver)
Regards
Manasi
Regards
Manasi
Flex logix ( 1794-L34)
- Thread starter manasi
- Start date
arun_mallah
Member
Manasi,
U need to configure AB DF1 driver in Rslinx. First ensure that u have a CP3 cable connected between the PC and the Flex PLC.
while configuring just use the Auto Config in Rslinx.
I hope this works for you.
Arun Sahani
U need to configure AB DF1 driver in Rslinx. First ensure that u have a CP3 cable connected between the PC and the Flex PLC.
while configuring just use the Auto Config in Rslinx.
I hope this works for you.
Arun Sahani
Similar Topics
Anybody can help me. I already read document in software rslogix 5000 and I think i can use software rslogix 5000 calibrate for flex module...
Good Evening ,
I am getting ready to install a remote Flex I/O 1794-AENT. It is going to be difficult to shut the line down to install. I...
Dear all,
I have 1794 IE8H Hart flex input module to which one Emerson HART flowmeter is connected...I have gone manual of flex module...I have...
So this is a first time I've had no choice but to use Flex I/O with anything RSLogix 5000. I've got everything up and running, but the values I...
I am using an oval gear meter with a pulse rate of 2050p's /L. I am trying to figure out how to program a rate counter to track flow rate at...