I need to connect a 2711 k6c9 panelview to a ML1200 PLC. I do have a spare 1761 cbl pm02 cable. What do i need to do to this cable to get the comms working between the two. Looks like i have to cross pins 2 and 3 on DB9. If anyone have experience with this pl help. Rockwell states that i need a null modem adapter. Is it some thing that you buy from a raido shop?
Comms Cable for ML1200 to Panelview
- Thread starter Ranjith
- Start date
The null modem adapter will do that for you.
Here in the states, I would usually go to Radio Shack to get one. Here's a link to what you need.
Here in the states, I would usually go to Radio Shack to get one. Here's a link to what you need.
Mickey
Lifetime Supporting Member
Please see PDF. A straight thru cable is what you need.
Similar Topics
I want to connect a PanelView 550 (2711-K5A2) from the DH485 port of a 5/03 to the DH485 of the PV, what comms cable would I need? I need to use...
i am looking to wire up my 5 PF4's on my home test rig on modbus i have the RJ45 plugs from AB and want to know what type of cable to use, i have...
Hi folks, i hope eveybody had a good Xmas and Nuyear.
I want to establish comms with an Slc 5/04 with a 1784PCMK/B card to a 1784-PCM5/B cable...
Folks,
A SLC503 used to be connected to the Internet via a Digi One IAP. During program download to the PLC the Internet connection was...
hi
i need to pc (pnoz conf.) to pilz communication cable pin-out schema or drawing.
or where can i find?
thanksxxx