SNK
Member
I am attempting to setup an Ethernet-DHRIO Controllogix-Rack Bridge setup.
My intent is to use the 1756-ENET card to communicate to a PC for a GE FIX32 application, rather than using the original 1784-KT cards that are currently used, hoping to utilize the DH+ part of the 1756-DHRIO card for HMI only.
I have about 12 Racks of RIO in 1771 racks, communicating to a few PLC-5's, and am hoping to be able to access the RIO data through this "Bridge" setup for the FIX32 application.
So, I have a
1756-Rack
1756-ENBT (A)
1756-DHRIO (C)
How do I setup this routing table? Right now, I cannot even change channel B from DH+ to RIO.
Is there any Rockwell information that is available for this type of setup? If so, I cannot find any.
Please let me know if you have any interesting information that you would like to share...
My intent is to use the 1756-ENET card to communicate to a PC for a GE FIX32 application, rather than using the original 1784-KT cards that are currently used, hoping to utilize the DH+ part of the 1756-DHRIO card for HMI only.
I have about 12 Racks of RIO in 1771 racks, communicating to a few PLC-5's, and am hoping to be able to access the RIO data through this "Bridge" setup for the FIX32 application.
So, I have a
1756-Rack
1756-ENBT (A)
1756-DHRIO (C)
How do I setup this routing table? Right now, I cannot even change channel B from DH+ to RIO.
Is there any Rockwell information that is available for this type of setup? If so, I cannot find any.
Please let me know if you have any interesting information that you would like to share...