1746-ni8 Class3 Status Bit Problem

I'm trying to configure a 1746-NI8 Class 3 input card. The card is set up for a 4-20 ma signal and that part of my configuration works fine. The config is a follows 0000100001000101. My trouble is when I read the status bits Open circuit (bit12), Over-range (bit13), Under range (bit 14). Note: the LED's on cards react properly but the bits do not work as I thought they should. Any help comments would be greatly appreciated!

welcome to the forum ... can you post your .RSS program? ... the more we know, the more detailed help we can provide ...

Problem found... I did not know that the status for I:e.0 is I.e.8. Justed needed to read the book a bit closer.