richensel Member R Join Date Jul 2003 Posts 2 Jul 18, 2003 #1 I am missing the communication cable to connect my PC to my Square D telemecanique TSX07 PLC. I have both ends (the PLC side takes a mini DIN 8 pin male) but need to know which pins should connect where. Any ideas, I struck out on SquareD's web site.
I am missing the communication cable to connect my PC to my Square D telemecanique TSX07 PLC. I have both ends (the PLC side takes a mini DIN 8 pin male) but need to know which pins should connect where. Any ideas, I struck out on SquareD's web site.
bob1371 Lifetime Supporting Member Join Date Mar 2003 Location Southern Indiana Posts 355 Jul 18, 2003 #2 check out this PDF for most of your cable needs. http://www.panel-tec.com/dn3000cbl.pdf Bob
richensel Member OP R Join Date Jul 2003 Posts 2 Jul 18, 2003 #3 Thanks, good info, but.... the cable I had connected using a DB-9 connector and this only tells me how to wire a DB-25 connector. That may not be a big deal, but I don't kow how to work around. Anything else?
Thanks, good info, but.... the cable I had connected using a DB-9 connector and this only tells me how to wire a DB-25 connector. That may not be a big deal, but I don't kow how to work around. Anything else?
PLucas Member Join Date Apr 2002 Location Gillingham Kent Posts 1,742 Jul 18, 2003 #4 If the comms cable is RS422 or RS232 you might be able to find the answer at this web site That site is a good source of information for cable's and connector pin outs. Thanks to whoever posted that link before, sorry I can't remember who it was. Paul
If the comms cable is RS422 or RS232 you might be able to find the answer at this web site That site is a good source of information for cable's and connector pin outs. Thanks to whoever posted that link before, sorry I can't remember who it was. Paul
Eric Nelson Lifetime Supporting Member + Moderator Join Date Apr 2002 Location Randolph, NJ Posts 4,346 Jul 18, 2003 #5 PLucas said: Thanks to whoever posted that link before, sorry I can't remember who it was Click to expand... You're welcome... beerchug -Eric
PLucas said: Thanks to whoever posted that link before, sorry I can't remember who it was Click to expand... You're welcome... beerchug -Eric