Question about Mits FX1S programming cable
- Thread starter gfr
- Start date
The FX range is 422 so an SC09 cable is required, however there are a few threads on here about a way to connect 232 to this plc, I have not tried it but from the replies it sounds like it works although I'm a bit dubious about what damage could be caused to some 232 ports (not heard of any yet).
Similar Topics
Hello,
I am doing a special project with a Mitsubishi FX1S. This is the first time I have ever done anything with a Mits PLC and I am trying to...
hi all. Does anyone know whether it's ok or just plain stupid to have 3 snd. and 3 rcv. ports open at the time on a QJ71E71 card? They're paired...
I have never had the pleasure of working with a "Thermistor" until now and have a question. The Thermistor is a 10KOhm 4-20mA 2-wire device and I...
Hi All,
So I have a main routine with an instruction that's executed by XIC "Run"
I have a JSR located on a rung below it. In the logic for that...
I have a 120V relay, 120V DI card and a analog input. I was wanting to know if i could put a 24V DI and well as a 120V DI card on the same plc...