Anayat Ali
Member
Hi. can any one help me. when i open a file in the CX-Programmer then when i close the CX-Programmer software it doesn't close but goes to the sleep mode and not responding. What is the resone? Thanks
CX-Programmer V7 Problem
- Thread starter Anayat Ali
- Start date
lostcontrol
Lifetime Supporting Member
Probably worth upgrading, I think CX-P is not at V9.
Anayat Ali
Member
OP
The same problem was in CX-Programmer V6 and then upgrade the version.
Similar Topics
I am stuck on what is likely a misunderstanding of how Omron handles data versus Rockwell.
I need to scale an analog input to monitor the...
hi,
i installed the cx programmer trial version with some error messages. after completion of the installation when i am trying to open the...
Hi there ,i'm using a CQM01 PLC for my project. I was just testing the input and output of my PLC with a very basic program with only one contact...
In the hand position:
Pumps 1 and 2 are controlled and alternated by the hand selector switch. When Hand position is first selected, pump 1...
Hi there,
PLC in question: 240VAC Omron CP1E-NA20DR-A
Features: 12 inputs – 2 of which analogue, 8 outputs – 1 of which analogue
My question is...