Hmi proface
- Thread starter helene
- Start date
Thanks for the reply. The type of the panel is GP477R. I have the application file (.prw) from the company that made that. But when I upload the application from the panel the size of the .prw file is smaller. I suppose that the settings of the transferring are not correct. Have you any idea?
SNK
Member
Proface panels were programmed with QuickPanel/Quickdesigner software....
There were a number of changes of ownership in the last 10 years, the last I heard is that GE purchased them.
They are EXTREMELY robust, and without a doubt, one of the best HMI's out there.
IF you can upload it, the file should be completely intact with all of the settings, OK for modifying/etc.
I seem to recall that the ones that I remember uploading were *.PRJ files though...
There were a number of changes of ownership in the last 10 years, the last I heard is that GE purchased them.
They are EXTREMELY robust, and without a doubt, one of the best HMI's out there.
IF you can upload it, the file should be completely intact with all of the settings, OK for modifying/etc.
I seem to recall that the ones that I remember uploading were *.PRJ files though...
Similar Topics
I have followed the videos & still having issues getting the email out. Does anyone have knowledge or has sent an email notification via gp pro ex?
Has anyone found a Proface HMI that is compatible with Schneider M172 PLC?
Hello Everyone,
I am hoping someone can point me in the right direction.
I have a Mitsubishi PLC FX3u connected to an old ProFace GP2500 HMI...
Hi fellas,
Hoping someone can help me get started with this. I'm a little out of my comfort zone trying to set up communication with a ProFace...
I am facing a Proface HMI device with password protected, the device is not allow for me to backup the graphic unless I key in the correct...