ABB AC800 Profibus problem

pincho

Member
P
Join Date
Mar 2010
Location
Rabat
Posts
3
Hello

I try to start-up an ABB controller AC800

The controler has a CI854 module, connected to a CI8101 module

I have set the Profibus module for CI801, (I put the same nomber than in the hardware congif)

Did i make mistake ? There s some Light on module nut i don t i have any documentation

So all tips are welcome

Thanks
 

Similar Topics

A
ABB AC800 n Seimens CPU314 profibus communication
Dear , i m establisting communication between ABB AC800 PLC(master) and Seimens CPU314(slave) on profibus .... but showing some configuration...
Replies
2
Views
2,893
plc_cnc
P
A
Communication Between siemens S7 400 PLC and Abb AC800 PLC
Dear Friends I have two PLCs 1. siemens S7 400 series 2. ABB AC800 I want to comunicate between these two PLC through two optical fibre...
Replies
4
Views
12,951
umencho
U
EICS
ABB PS501 Control Builder Plus V2.3 Install - anyone use it or know of it
does anyone have an install or know if/where i can download it for the following "ABB PS501 Control Builder Plus V2.3 " the software was a free...
Replies
2
Views
127
ojz0r
O
S
IE5 ABB motor and VFD
Hello, It is mandatory to use VFD IF i use IE5 electrical motor? What happens If connect it directly as delta without VFD? Please look at motor...
Replies
1
Views
177
kamenges
K
R
ABB ACS800-07 VSD fault on ramp up between 98 and 100%
Hi hoping someone can assist me with current issue I am experiencing with an ABB drive. Problem I’m experiencing is a ABB drive supply a large...
Replies
4
Views
237
BryanG
B
Back
Top Bottom