write a DRILL PRESS program

Guest · Oct 22, 2003

am just learning plc and i need someone to help me write a drill press program. it suppose to do this

*push start conveyor motor run the part to clamp
*work present hit stop and conveyor stop and clamp part
*drill motor start move down and drill the parrt
*when finish drill is set reverse and drill move up and reset process

i have a attach a dragram if u want to c it
PLEASE HELP ME

Matthias von Zorn · Oct 22, 2003

By all means, post the work you have done so far. Doing so will get you 1000x the help and 1000x less smart comments.

RDay · Oct 22, 2003

More important than a diagram, where is the code that you have been so laboriously working on to no avail? You will find help here if you show some effort on your part.

hh2000 · Oct 23, 2003

can u guyz help me start on it i be very apperciated

Eric Nelson · Oct 23, 2003

Originally posted by hh2000
i have a attach a dragram if u want to c it

You (or u) have NOT "a attach a dragram", and YES, we "want to c it"... :nodi:

beerchug

-Eric

Matthias von Zorn · Oct 23, 2003

See, the basic rule around here is show us your work so far, and we'll work to help you out.

Rick Densing · Oct 23, 2003

Start by thinking what inputs and outputs you would need.

write a DRILL PRESS program

Guest

Guest

Matthias von Zorn

Member

RDay

Member

hh2000

Member

Eric Nelson

Lifetime Supporting Member + Moderator

Matthias von Zorn

Member

Rick Densing

Member

Similar Topics