View Full Version : What is this for? GE fanuc 90-30 MOVE INT etc..
April 26th, 2011, 11:12 PM
HI GUYS,, what is "length",
for what is it?
can anyone help me with this?
the "4" is chosen from range 0-256 (256 is the limit)
April 27th, 2011, 12:53 AM
does it mean 1-256 is decimal number?
April 27th, 2011, 12:58 AM
In my case, %R00008 is the quotient from DIV INT
so the quotient is in INT type of data then will move to AQ0001.
Im confuse about the 1-256 length
Thanks for your reply
April 27th, 2011, 01:00 AM
See PDF below for instruction help.
April 27th, 2011, 01:01 AM
By the way, the manual is very helpful
April 27th, 2011, 01:10 AM
Sir I think the length is the number of bits to be move, in my case , when move int is activated %R0008,%R0009,%R0010,%R0011 will be moved to AQ0001 AQ0002 AQ0003 AQ0004..
Is this correct?
April 27th, 2011, 05:55 AM
You are correct. If, instead of %R0008 at the "IN" node, you had a constant, then that constant would be copied to all four destination addresses.
April 27th, 2011, 07:25 PM
OK Sir, Thank you very much for your answers...