control fault in wincc client

jclompen

Member
J
Join Date
Jun 2011
Location
aaigem
Posts
1
hy all,
am having a problem in wincc.
when i insert an control from the libery it is vissible on the server but it apears as a white square on the clients. al the properties heve remaint.

i would apricciate it if someone can help me with this.

joachim
 

Similar Topics

H
PowerFlex 525 fault on Network even in LOCAL control
So our Powerflex 525's are set up to allow REMOTE operation from PLC through network. But if network is lost we want to be able to run in LOCAL...
Replies
5
Views
587
robertmee
R
M
CompactLogix 1769-L33ER Motion Control Axis in fault.
Hey guys, On my system, i got prop valve controling cylinder on the left and right to adjust the center of a lumber before it get in a woodmill...
Replies
8
Views
954
mike3475
M
D
"control synch fault"- kinetix 5500
Hi. We are using a kinetix 5500 to control an eccentric conveyor motor. We are experiencing sporadic and intermittent occurrences of a "Control...
Replies
5
Views
5,840
dmroeder
dmroeder
P
1769-AENTR Fault Control
I have 1769-L35E CompactLogix controller communicating to two 1769-AENTR. While testing, I can pull the Ethernet cable and I get a major fault...
Replies
7
Views
3,530
ronny_resistor
ronny_resistor
Dustin11H3
1756-L8 Series Control Logix Fault Bits
Hey All, I have a 1756-L81E. There is a piece of code I only want enabled when I don't have a communication error present from the ethernet...
Replies
8
Views
5,225
dmroeder
dmroeder
Back
Top Bottom