tgriswold
Member
I am new to Mitsubishi and I am having difficulty understanding the multiple ways to force a contact or coil. I am using GX Works2.
Shift/Enter will change the state of the contact but no way of searching for this once it has been changed.
There is also "Forced Input Output Registration/Cancellation".
Then there is "Register Device Test with Execution Condition".
Both of these seem to work fine but not sure if input is forced in just that step or the entire program.
My question is, what is the difference between these and what one should we train our technicians on. I have attended the basic Mitsubishi class but this was not covered.
Any Help would be Greatly Appreciated....
Shift/Enter will change the state of the contact but no way of searching for this once it has been changed.
There is also "Forced Input Output Registration/Cancellation".
Then there is "Register Device Test with Execution Condition".
Both of these seem to work fine but not sure if input is forced in just that step or the entire program.
My question is, what is the difference between these and what one should we train our technicians on. I have attended the basic Mitsubishi class but this was not covered.
Any Help would be Greatly Appreciated....
