kumar satyam
Member
can any one plz tell me how to take fc in series in siemens
s7 300 simaic manager
- Thread starter kumar satyam
- Start date
Liam Moran
Lifetime Supporting Member
Can you rephrase the question?
From your request wording, I have no idea what you require.
From your request wording, I have no idea what you require.
kumar satyam
Member
OP
there are functionschart in simatic manager as FC1 and FC@ and so on.....
after creating them i cant use them in series
i hope i am clearto my point
after creating them i cant use them in series
i hope i am clearto my point
L D[AR2P#0.0]
Lifetime Supporting Member
In series like this ?
kumar satyam
Member
OP
Ya
of course
of course
JRW
Member
Inside your fc (on the last network)
type
set
save
ya- of course
this works
type
set
save
ya- of course
this works
Similar Topics
Dear All,
Currently i'm working with Endress Hauser flowmeter and AB PLC and try to integrate with 2 items.
Flow meter spec using is Promass...
in allen bradley kinetix 300 drive first E31 error shows after resting drive E11 error occurs need solution to reset E11 fault code
Hi,
I'm setting up a modbus master on an S7-300. It seems to work in OB1 but not when I use it in OB35. Does anyone have any ideas why?
Could...
So basically i have 2 queries :
1. I have a program file of S7-300 PLC which i want to migrate in RSLogix500.In short i want to convert my simatic...
Hi i using Kinetik 300 2097 driver control by EIP with using move absolute and incremental for motion , but i want to add same driver and motor as...