s5 to s7 convert

tulip

Member
T
Join Date
Oct 2005
Location
ist
Posts
236
When I convert a program some blocks are not available in s7 side ( FB201,FB208,FB215,FB217,FB218 ) .And convert program is giving a lot of errors.(For example FB240 )How can I correct these errors?Any experience.....?
 

Similar Topics

I
Make an HMI convert from inches to PUUs (numeric input) before writing to servo drive
Hello all, I'm currently working on a servo motor linear positioning system (ball screw). I'm all set up regarding communication between my HMI...
Replies
1
Views
111
parky
P
F
Incremental Encoder Convert to Degree
I have an application using an incremental encoder and then I convert it to degree (0-360) using calculation program. For a while, the calculation...
Replies
8
Views
359
feisaladam
F
dalporto
Rockwell - Convert Two INT to REAL
Hi all. Me again still learning Rockwell. So I'll be polling an INT data array from a Modbus SE power meter with a L82 (with a Modbus ProSoft in...
2 3 4
Replies
56
Views
1,459
drbitboy
drbitboy
K
convert RSP files to PDF
Hello, could someone kindly convert the attached RSP files that are currently used for SLC 5 PLC into PDF please
Replies
6
Views
554
hardaysknight
H
J
Rockwell .rss to .slc to convert
I'm trying to convert an RS Logix 500 fille when I open the 500 file and try to "save as" a .slc file, it does not allow it. It says " SLC library...
Replies
7
Views
716
DannyH
D
Back
Top Bottom