ceilingwalker
Lifetime Supporting Member
Good day all. I have a question about testing I/O's using the "I/O Configuration" page in RSLogix5. I'm trying to find out if the remote I/O is sending an analog signal to the SCR's that are firing the VRT's for a heating process. Is it possible to change settings on the I/O config page to test signals going to the SCR's? The project I'm working with uses PID settings to attain the desired temp and it ramps and soaks up to 1832-degrees F, very slowly (I do not know the exact rate's). I wanted to turn it on full-power to get it to temp but the PID settings over-ride my manual attempt. Thank you.